1. The next step is the process of making flower drawing. Use a knife to cut along the lines of the pattern on the watermelon skin, the cutting depth should be moderate, do not cut the whole watermelon skin. After cutting, gently pull the watermelon skin outward with your hand. If you cut at a moderate depth, the watermelon peel will be easily pulled open to form a beautiful flower-pulling effect. Finally, put the watermelon peel flowers in a dry and ventilated place to dry.
2. Children draw flowers by hand as follows: take a long piece of paper. Cut thin strips from one side with scissors. Note: do not cut to the end, if you are afraid of cutting, you can draw the mark line in advance; the interval is as uniform as possible. After cutting one side, turn around and cut the other side in the same way. Note: when cutting, cut under the scissors in the middle of the two incisions on the other side, that is, the two sides are staggered to cut each other. Start at one end and cut to the other end.
3. The production method of hand-drawn flowers is as follows: prepare materials: scissors, long-tail ticket clip, red paper, gold paper, double-sided glue and so on. Fold the red paper into a triangle and cut it into thin strips with scissors. Paste the gold paper on the red strip with double-sided glue as the bottom of the flower. Open the long-tail ticket clip and clip it in the center of the bottom of the flower.
4. Children's hand-drawn flowers are made as follows: prepare four ribbons, each ribbon can be cut into 750px length, fold each ribbon in half, one side is about 2CM longer than the other. Cross the "+" shape of the folded ribbon in turn and tighten it. Fold the ribbon on either side into a small triangle and insert it. Make the eight triangles in turn. Flip the ribbon, insert it in turn, and finish the effect drawing.
5. Prepare materials: scissors, paper, glue, paintbrush, etc. Design happy word pattern: first of all, you need to design a good happy word pattern, you can design your own creative design, you can also refer to some traditional happy word patterns. Cut out the shape of the happy word: cut the paper into a square or make a rectangular shape, and then cut the shape of the happy word along the pattern lines of the happy word.
6. Preparation: choose the materials you need, and prepare other tools and materials you need. Stick the double-sided adhesive on the back of the drawing material to secure it in the desired position. Cut the flower, and use scissors to cut the material to the desired shape and size. You can try to use a ruler to measure to ensure the accuracy of the cut. Paste pattern: paste the cut pattern material on the desired decoration position.
When dealing with the tail of the ribbon, the ribbon needs to be fully unfolded first. Hold the part between the bow and the string that needs to be curled with one hand to make sure it is firm. At the same time, use the other hand to hold a ruler or other similar tool with a sharp edge and enough hardness. This tool will be used to help curl the string to form a beautiful pattern.
Separate the ribbon at the end of the ribbon. 2 see that there is a core inside. 3 hold the separated ends of the ribbon with your hand, and then pull the core inside, and you can get a flower.
First, tie a knot. Press the knot with your right hand and pull up the ribbon on the left. Then tie another knot, but not too tightly this time. Overlap the two ribbons and circle the left hand. Pass the two ribbons between the two knots and open them to form a circle slightly smaller than the left hand. Finally, tighten it with the ring on the left and arrange the shape of the ribbon.
Tie a knot. Press and hold your right hand and pull up the ribbon on the left. Tie another knot, but not solid. Overlap the two ribbons and make a circle on the left hand. The two ribbons pass through and open between the two knots and circle a circle slightly smaller than the left hand.
Do-it-yourself pull flowers, look at the picture ribbon flower production method steps on it. Isn't it easy. Cut the note into several pieces of different lengths. Then first make the flower of the outer ring, then stand it with glue, and then make the little flower on the inside of the flower, so that from the outside to the inside, it will eventually become the same ribbon flower as the blooming flower. Isn't it beautiful to embellish the gift wrapping box?
Gift packaging pull flower: first of all, wrap the tape into a circle, fold it in half and cut the ribbon on both sides, then fold it back in half, tie it tightly with a ribbon, and try to pull it out slowly. It looks very complicated. It's easier to try it.
First, tie a knot. Press the knot with your right hand and pull up the ribbon on the left. Then tie another knot, but not too tightly this time. Overlap the two ribbons and circle the left hand. Pass the two ribbons between the two knots and open them to form a circle slightly smaller than the left hand. Finally, tighten it with the ring on the left and arrange the shape of the ribbon.
Tie a knot. Press and hold your right hand and pull up the ribbon on the left. Tie another knot, but not solid. Overlap the two ribbons and make a circle on the left hand. The two ribbons pass through and open between the two knots and circle a circle slightly smaller than the left hand.
When dealing with the tail of the ribbon, the ribbon needs to be fully unfolded first. Hold the part between the bow and the string that needs to be curled with one hand to make sure it is firm. At the same time, use the other hand to hold a ruler or other similar tool with a sharp edge and enough hardness. This tool will be used to help curl the string to form a beautiful pattern.
First unfold the flower and use one hand to grasp the part between the bow and the tail that needs to be curled. In the other hand, hold a ruler with a thin edge and a hard material, or something similar. Place the curled part of the rope between the ruler and the index finger, then drag down with the edge of the ruler, using this force to curl the rope.
The belt on the gift box can be crossed into a cross shape, then the left index finger and thumb are pinched and turned into a half circle, and the right hand is turned in half a circle, and then cross the cross flower shape on both sides.
1. First of all, prepare a square piece of paper and fold it into a triangle. Fold it into a triangle again. Continue to fold in half into triangles. After folding in half, draw a line on the paper as shown in the picture and cut it with scissors. After cutting the shape, draw a line on it as shown in the picture and then continue to cut. After cutting, it will unfold into a "flower" shape. Hold both sides of the "flower" and unfold.
2. Glue the tops of the two flowers together, either with glue or a stapler. A simple combination of pull flowers is done.
3. The practice of drawing flowers is as follows: the tools needed to make flowers are scissors, pencils and red paper, red paper. Fold the red paper in half along the two diagonals to form a triangle. Fold the two acute angles of a triangle together to form another triangle. Fold the triangle in half again along the middle line of an acute angle to change the 45-degree angle to 25 degrees.
4. The flower drawing is made by the method of color paper cutting. The methods are as follows: tools: square colored paper, scissors. Prepare six pieces of square colored paper of the same size and different colors. Fold the corner of a square colored paper in half to form a small triangle. Then fold the angle under the triangle paper in half to form a small triangle. Fold the angle of the triangle paper in half to form a small triangle again.
5. Prepare four ribbons, each ribbon can be cut into 750px length, and fold each ribbon in half (one side is about 2CM longer than the other). Cross the "+" shape of the folded ribbon in turn and tighten it.
6. The production method of hand-drawn flowers is as follows: prepare materials: scissors, long-tail ticket clip, red paper, gold paper, double-sided glue, etc. Fold the red paper into a triangle and cut it into thin strips with scissors. Paste the gold paper on the red strip with double-sided glue as the bottom of the flower. Open the long-tail ticket clip and clip it in the center of the bottom of the flower.